Tianjin Tianyingtai Steel Pipe Co., Ltd. is one of the most credible manufacturers and suppliers of spiral steel pipe in China. Welcome to consult the quotation and import cheap spiral steel pipe made in China here from our factory.
Product Info
The spiral steel pipe is a spiral seam steel pipe which is made of steel coiled coil as raw material, which is often heated and extruded, and welded by automatic double wire double-sided submerged arc welding process. The spiral steel pipe feeds the strip steel into the welded pipe unit. After rolling through multiple rolls, the strip is gradually rolled up to form a circular tube blank with an open gap. The reduction of the pressing roll is adjusted to control the weld gap in 1~ 3mm and make the ends of the solder joint flush.
Production Process
1) Raw materials are strip coils, welding wire, flux. Strict physical and chemical testing is required before input.
(2) The steel head and tail are butt jointed, and the single wire or double wire submerged arc welding is used, and the automatic submerged arc welding is used after the steel pipe is rolled.
(3) Before forming, the strip is leveled, trimmed, planed, surface cleaned and pre-bent.
(4) The electric contact pressure gauge is used to control the pressure of the cylinder on both sides of the conveyor to ensure the smooth conveying of the strip.
(5) Adopt external control or internal control roll molding.
(6) The weld gap control device is used to ensure that the weld gap meets the welding requirements, and the pipe diameter, the amount of misalignment and the weld gap are strictly controlled.
(7) Both inner and outer welding are performed by single-wire or double-wire submerged arc welding using a Lincoln electric welder in the United States to obtain stable welding quality.
(8) The welded seams are all inspected by online continuous ultrasonic automatic injury inspection to ensure the non-destructive testing coverage of 100% spiral welds. If there is a defect, the alarm is automatically alarmed and sprayed, and the production worker adjusts the process parameters at any time to eliminate defects in time.
(9) The steel pipe is cut into individual pieces by an air plasma cutting machine.
(10) After cutting into a single steel pipe, each batch of steel pipe shall undergo a strict first inspection system to check the mechanical properties, chemical composition, fusion condition, surface quality of the steel pipe and non-destructive testing to ensure the pipe making process. After that, it can be officially put into production.
(11) The part of the weld with continuous acoustic flaw detection mark, after manual ultrasonic and X-ray review, if it is defective, after repair, it will pass the non-destructive test again until it is confirmed that the defect has been eliminated.
(12) The tube of the butt weld of the strip and the joint of the butt joint intersecting the spiral weld are all inspected by X-ray television or film.
(13) Each steel pipe is subjected to hydrostatic pressure test and the pressure is radially sealed. The test pressure and time are strictly controlled by the steel pipe water pressure microcomputer detection device. Test parameters are automatically printed and recorded.
(14) The pipe end is machined to make the end face verticality, groove angle and blunt edge accurately controlled.
Application
Spiral steel pipe is mainly used in water supply engineering, petrochemical industry, chemical industry, electric power industry, agricultural irrigation, urban construction, and is one of the 20 key products developed in China.
For liquid transportation: water supply and drainage. For gas transportation: gas, steam, liquefied petroleum gas. For structural use: for piling pipes, for bridges; for piers, roads, building structures, etc.
Hot Tags: spiral steel pipe, made in China, manufacturers, suppliers, ERW Galvanized Steel Pipes, Mild Steel Oiled Rectangular Pipes, Black pipe, Gi Square Hollow Section, N80 Galvanized Pipe, Galvanized Pipe For Malaysia Market
