Sizing and straightening:
Here we will do the pipe calibration. Through this part, pipes sizes will be more accurate and be straighter.
Our latest machines can control the tolerance into a smaller range.
But except size is more accurate, the pipe length is also a important factor we are concerned about.
So next step about the pipe length control is Cutting:
The pipe length tolerance usually we control it in: -0, +20mm. So buyers don’t need to worry about that the pipe will be shorter that what you want.
Think of cutting, a pipe problem bears in my mind. I believe that most of pipe buyers bought the pipes with burring end sometimes. That is caused by the cutting machine – flying saw. As our company regulation, our flying saw and the saw blade must be the latest. So our flying saw blade will be replaced in a regular interval so that our pipe ends never have the burring end problem. Pls look at the right picture. The pipe end is so clean.
